Allied Telesis AT-GS908M - Set Mstp Msti

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 397
SET MSTP MSTI
Syntax
set mstp msti= instance priority= priority
Parameters
instance
Specifies MST instance ID.
priority
Specifies the bridge priority for the MST instance. The smaller
number has higher priority to be a root bridge.The range is 0 to
65535. The default value is 32768. The switch converts the
specified number into an increment of 4096, which is close to and
smaller than the specified number. For example, when you
specifies 10,000, the switch sets the priority to 8192.
Description
Use this command to set the bridge priority to the specified MST instance.
Confirmation Command
“SHOW MSTP” on page 399
Examples
The following command sets the bridge priority of MST instance 5 to 8192:
set mstp cist priority=8192