Chapter 22: Access Filter Commands
406 Section IV: Security and Traffic Control
ADD ACCESS FILTER
Syntax
add access filter=snmp|ftp|telnet|http|icmp|global
ipaddress=
ip_address
mask=
mask
action=pass|discard
port=
port_list
|all
Parameters
filter
Specifies one of the access filter groups to the access filter entry.
snmp
Specifies the entry to add to the group snmp.
ftp
Specifies the entry to add to the group ftp.
telnet
Specifies the entry to add to the group telnet.
http
Specifies the entry to add to the group http.
icmp
Specifies the entry to add to the group icmp.
global
Specifies the entry to add to all the groups.
ip_address
Specifies the IPv4 address of the target.
mask
Specifies the mask to filter the IPv4 address.
action
Specifies the action when a packet matches the access filter.
pass
Passes the packet when it matches the access filter.
discard
Discard the packet when it matches the access filter.
port_list
Specifies a switch port number or list of port numbers. To specify
multiple port numbers, separate port numbers using a comma or
use a hyphen to specify the range of port numbers.
To Next Page
Loading...
