Allied Telesis AT-GS908M - Delete Access Filter Entry

Chapter 22: Access Filter Commands
408 Section IV: Security and Traffic Control
DELETE ACCESS FILTER ENTRY
Syntax
delete access filter=snmp|ftp|telnet|http|icmp|global
entry=
entry_number
Parameters
filter
Specifies the access filter group of the access filter. See “ADD
ACCESS FILTER” on page 406.
filter
Specifies one of the access filter groups.
snmp
Specifies the group snmp.
ftp
Specifies the group ftp.
telnet
Specifies the group telnet.
http
Specifies the http.
icmp
Specifies the group icmp.
global
Specifies all the groups.
entry_number
Specifies the number of the access filter entry. The entry number
of an access filter is shown on the list. See “SHOW ACCESS
FILTER” on page 415.
Description
Use this command to delete the specified access filter entry.
Confirmation Command
“SHOW ACCESS FILTER” on page 415