Chapter 22: Access Filter Commands
410 Section IV: Security and Traffic Control
DISABLE ACCESS FILTER
Syntax
disable access filter=snmp|ftp|telnet|http|icmp|global|all
Parameters
filter
Specifies an access filter group. See “ADD ACCESS FILTER” on
page 406.
global
Specifies all the access filter groups.
all
Specifies the access filter entries: snmp, ftp, telnet, http, and icmp.
Description
Use this command to disable the access filter feature on the specified
access filter group or all the access filter entries.
Confirmation Command
“SHOW ACCESS FILTER” on page 415
Example
The following command disables the access filter features for TFTP
service:
Manager > disable access filter=tftp
To Next Page
Loading...
