Chapter 26: Policy-Based QoS Commands
496 Section IV: Security and Traffic Control
SHOW QOS TRAFFICCLASS
Syntax
show qos trafficclass[=
traffic_class_list
|all]
Parameters
traffic_class_list
Specifies a list of traffic classes. To specify multiple traffic classes,
use a comma (,) to separate them. To specify a range of traffic
classes, use a hyphen (-).
Description
Use this command to display the settings of traffic classes. An example of
the command output is shown in Figure 75.
Figure 75. SHOW QOS TRAFFICCLASS Command
Example
The following example displays the settings of traffic classes:
Manager > show qos trafficclass
---------------------------------------------
Traffic Class ID ..... 0
Description ..........
Exceed Action ........ Drop
Exceed Remark Value .. 0
Mark Value ...........
Max bandwidth ........
Burst Size ...........
Priority .............
Remark Priority ...... No
Flow Group List ......
Parent Policy ID .....
Is Active ............ No
To Next Page
Loading...
