AT-GS900M Series CLI Reference
Section I: Getting Started 81
SET CONFIG
Syntax
set config=[
file_name
|none]
Parameters
file_name
Specifies the name of a configuration file. When rebooting, the
switch uses this file as the start-up configuration file.
none
Specifies no file. When rebooting, the switch starts with the default
configuration.
Description
Use this command to assign the start-up configuration file.
Confirmation Command
“SHOW CONFIG” on page 85
Example
The following command resets the switch to the default configuration:
Manager> set config=none
The following command assigns the config3.cfg file as the start-up
configuration file:
Manager> set config=config3.cfg
To Next Page
Loading...
