Chapter 5: Basic Operations Commands
82 Section I: Getting Started
SET FTP LISTENPORT
Syntax
set ftp listenport=
port_number
Parameter
port_number
Specifies the port number of TCP port for FTP control. The port
number is from 1 to 65535.
Description
Use this command to change the TCP port for FTP control. By default, the
FTP control port is 21.
Confirmation Command
“SHOW FTP” on page 88
Example
The following command changes the TCP port for FTP control to 150.
Manager> set ftp listenport=150
To Next Page
Loading...
