Chapter 5: Basic Operations Commands
84 Section I: Getting Started
SET TFTP LISTENPORT
Syntax
set tftp listenport=
port_number
Parameter
port_number
Specifies the port number of UDP port for the TFTP server. The
port number is from 1 to 65535.
Description
Use this command to change the UDP port for the TFTP server. By
default, the UDP port for the TFTP server is 69.
Confirmation Command
“SHOW TFTP” on page 90
Example
The following command changes the UDP port for the TFTP server to 100.
Manager> set tftp listenport=100
To Next Page
Loading...
