Allied Telesis AT-GS950 - Installing the Switch in a Rack

Chapter 2: Installation
34
Installing the Switch in a Rack
To install the AT-GS950/48 Gigabit Ethernet Smart switch in a rack,
perform the following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Install a bracket on one side of the switch using a Phillips screwdriver
and four of the rack-mount screws included with the switch, as shown
in Figure 7
Caution
The brackets provided must be used to securely mount the switch
on the rack..
Figure 7. Attaching the Rack-Mount Bracket
3. Repeat step 2 to attach the remaining bracket to the other side of the
switch.
4. Mount the switch on a 19-inch rack, as shown in Figure 8.
Figure 8. Mounting the Switch on the Rack
45R 47R
46R 48R
45 46 47 48
CLASS 1
LASER PRODUC T
AT-GS950/48
48 Port 10/100/1000 Mbps W
ebSmart Switch with 4 Combo SFP Ports
LINK
1000M
ACT
100M
10M
PORT ACTIVIT Y
SFP
1080
45R 47R
46R
48R
45 46 47 48
CLASS 1
LASER PR
O
DU
CT
AT-GS950/48
48
P
o
r
t 1
0/1
00/100
0 M
b
p
s
WebS
m
art S
w
itch
w
ith 4
C
o
m
b
o S
F
P Por
ts
LINK
1000M
ACT
100M
10M
PORT ACTIVIT Y
SFP
1081