AT-SBx908 Gen2 Switch Installation Guide
101
Do not strip more than the recommended amount of wire. Stripping
more than the recommended amount can create a safety hazard by
leaving exposed wire on the terminal block after installation. E10
Figure 70. Stripping the Power Wires
You must use stranded wires with the terminal lugs. You may not
use solid wires.
2. Insert the power wires into the terminals included with the power
supply and use a crimping tool to secure the wires to the terminals.
See Figure 71.
Figure 71. Attaching the Power Wires to the Right Angle Terminal Lugs
3. Verify that the On/Off switch on AT-SBxPWRSYS1-80 DC Power
Supply is in the Off position. Refer to Figure 54 on page 87.
4. Using a #1 Phillips-head screwdriver, remove the two screws that
secure the plastic cover over the positive and negative terminals and
remove the plastic cover from the power supply, as shown in Figure 72
on page 102. You may need to lift the locking handle slightly to access
the bottom screw.
To Next Page
Loading...
