Chapter 5: Cabling the Networking Ports
120
Installing 1GBase SFP or 10GBase SFP+ Transceivers in AT-XEM2-
12XS Line Cards
This section contains installation instructions for SFP or SFP+
transceivers in AT-XEM2-12XS Line Cards.
The illustrations in the procedure show a transceiver with a duplex LC
connector. The connectors on your transceivers may be different.
To install SFP or SFP+ transceivers, perform the following procedure:
1. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
2. Slide the transceiver into the slot until it clicks into place.
To install the transceiver into an odd numbered slot, position its handle
on the right. To install the transceiver into an even numbered slot,
position its handle on the left. Refer to Figure 85.
Figure 85. Installing an SFP Transceiver
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 4 to install
the remaining transceivers in the switch.
3. Remove the dust cover from the transceiver, as shown in Figure 86 on
page 121.
To Next Page
Loading...
