Chapter 5: Cabling the Networking Ports
126
Installing AT-QSFPCU Cables in QSFP+ Slots
This section contains instructions on how to install AT-QSFPCU Cables in
the four QSFP+ slots in the AT-XEM2-4QS Line Card. You can use the
cables in place of fiber optic cables and transceivers for 40GbE links of up
to 1 or 3 meters. The model names of the cables are listed here:
AT-QSFP1CU - 1 meter
AT-QSFP3CU - 3 meters
Please review “Guidelines to Handling SFP, SFP+, and QSFP+
Transceivers” on page 119 before performing this procedure.
To install AT-QSFPCU Cables, perform the following procedure:
1. Remove the dust cover from a QSFP+ slot in the switch. Figure 90
shows the removal of the dust cover from slot 17.
Figure 90. Removing the Dust Cover from a Slot on the AT-XEM2-4QS
Line Card
2. Orient the connector on the AT-QSFPCU Cable with the release tab
on the left side and slide it into the slot until it clicks into place. Refer to
Figure 91 on page 127.
To Next Page
Loading...
