Allied Telesis AT-SBx908 Gen2 - Figure 91: Sliding the AT-QSFPCU Cable into the Slot

AT-SBx908 Gen2 Switch Installation Guide
127
Figure 91. Sliding the AT-QSFPCU Cable into the Slot
3. Install the other end of the cable into a compatible QSFP+ slot on
another network device.
4. Repeat this procedure to install additional AT-QSFPCU Cables.
Note
To remove the connector and cable from the slot, gently push on the
connector, pull on the release tab, and slide the connector from the
slot.
Release Tab