Allied Telesis AT-SBx908 Gen2 - Figure 24: Removing the Grounding Lug from the Chassis; Figure 25: Attaching the Grounding Wire to the Grounding Lug

AT-SBx908 Gen2 Switch Installation Guide
59
Figure 24. Removing the Grounding Lug from the Chassis
3. Insert one end of the grounding wire into the grounding lug, as shown
in Figure 25, and use a crimping tool to secure the wire to the
grounding lug.
Figure 25. Attaching the Grounding Wire to the Grounding Lug
4. Install the grounding lug on the rear panel of the chassis. Refer to
Figure 26 on page 60.