Allied Telesis AT-SBx908 Gen2 - Figure 33: Lifting the Locking Handle on the AT-Sbxpwrsys1-80 DC Power Supply; Figure 34: Inserting the AT-Sbxpwrsys1-80 DC Power Supply

AT-SBx908 Gen2 Switch Installation Guide
67
Figure 33. Lifting the Locking Handle on the AT-SBxPWRSYS1-80 DC
Power Supply
6. Carefully align the power supply in the slot and slide it into the slot until
it makes contact with the connector inside the chassis. Refer to
Figure 34.
Figure 34. Inserting the AT-SBxPWRSYS1-80 DC Power Supply
7. Gently press on the faceplate of the power supply to seat the unit on
the connector on the backplane of the chassis, and lower the locking
handle to secure the unit in the chassis. Refer to Figure 35 on page 68.