Allied Telesis AT-x210-9GT - Show Debugging Radius

C613-50105-01 REV C Command Reference for x210 Series 1000
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RADIUS COMMANDS
SHOW
DEBUGGING RADIUS
show debugging radius
Overview This command displays the current debugging status for the RADIUS servers.
Syntax
show debugging radius
Mode User Exec and Privileged Exec
Example To display the current debugging status of RADIUS servers, use the command:
awplus# show debugging radius
Output Figure 29-1: Example output from the show debugging radius command
RADIUS debugging status:
RADIUS event debugging is off 
RADIUS packet debugging is off