Allied Telesis AT-x210-9GT - Show Running-Config Interface

C613-50105-01 REV C Command Reference for x210 Series 103
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
SHOW
RUNNING-CONFIG INTERFACE
show running-config interface
Overview This command displays the current configuration of one or more interfaces on the
device.
Syntax
show running-config interface [<interface-list>] [dot1x|ip
igmp|ip multicast|ip pim dense-mode|ip pim sparse-mode|ipv6
rip|lacp|mstp|ospf|rip|rstp|stp]
Mode Privileged Exec and Global Configuration
Default Displays information for all protocols on all interfaces
Examples To display the current running configuration of your device for ports 1 to 4, use the
command:
awplus# show running-config interface port1.0.1-port1.0.4
Parameter Description
<interface-list> The interfaces or ports to display information about. An
interface-list can be:
• a VLAN (e.g. vlan2), a LAN port (e.g. port1.0.4), a static
channel group (e.g. sa2) or a dynamic (LACP) channel
group (e.g. po2)
• a continuous range of VLANs, ports, static channel
groups or dynamic (LACP) channel groups, separated by
a hyphen (e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2)
• a comma-separated list of the above (e.g.
vlan2,vlan20-30). Do not mix interface types in a list.
The specified interfaces must exist.
dot1x Displays running configuration for 802.1X port
authentication for the specified interfaces.
lacp Displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
ip igmp Displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
ip multicast Displays running configuration for general multicast
settings for the specified interfaces.
mstp Displays running configuration for MSTP (Multiple
Spanning Tree Protocol) for the specified interfaces.
rstp Displays running configuration for RSTP (Rapid Spanning
Tree Protocol) for the specified interfaces.
stp Displays running configuration for STP (Spanning Tree
Protocol) for the specified interfaces.