32
C613-50105-01 REV C Command Reference for x210 Series 1038
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP Snooping
Commands
Introduction
Overview This chapter gives detailed information about the commands used to configure
DHCP snooping. For detailed descriptions of related ACL commands, see IPv4
Hardware Access Control List (ACL) Commands. For more information about DHCP
snooping, see the DHCP Snooping Feature Overview and Configuration Guide.
DHCP snooping can operate on static link aggregators (e.g. sa2) and dynamic link
aggregators (e.g. po2), as well as on switch ports (e.g. port1.0.2).
Command List •“arp security” on page 1040
•“arp security violation” on page 1041
•“clear arp security statistics” on page 1043
•“clear ip dhcp snooping binding” on page 1044
•“clear ip dhcp snooping statistics” on page 1045
•“debug arp security” on page 1046
•“debug ip dhcp snooping” on page 1047
•“ip dhcp snooping” on page 1048
•“ip dhcp snooping binding” on page 1049
•“ip dhcp snooping database” on page 1050
•“ip dhcp snooping delete-by-client” on page 1051
•“ip dhcp snooping delete-by-linkdown” on page 1052
•“ip dhcp snooping max-bindings” on page 1053
•“ip dhcp snooping trust” on page 1054
•“ip dhcp snooping verify mac-address” on page 1055
•“ip dhcp snooping violation” on page 1056
•“ip source binding” on page 1057
To Next Page
Loading...
