C613-50105-01 REV C Command Reference for x210 Series 1106
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RRP SNOOPING COMMANDS
IP
RRP SNOOPING
ip rrp snooping
Overview Use this command to enable RRP snooping.
Use the no variant of this command to disable RRP Snooping.
Syntax
ip rrp snooping
no ip rrp snooping
Default The default is disabled.
Mode Global Configuration
Usage Use this command to enable the RRP Snooping feature. You cannot use RRP
Snooping at the same time as the following features:
• STP, RSTP, or MSTP, except for edge ports. RSTP is enabled by default. To
disable it, use the command spanning-tree enable on page 495.
• Port security (the command switchport port-security)
• Port authentication
•EPSR
• Port mirroring
Examples The example below shows you how to enable RRP Snooping.
awplus# configure terminal
awplus(config)# ip rrp snooping
Related
Commands
show ip rrp snooping
To Next Page
Loading...
