C613-50105-01 REV C Command Reference for x210 Series 1145
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
ATMF
GUEST-CLASS
atmf guest-class
Overview This modal command creates a guest-class. Guest-classes are modal templates
that can be applied to selected guest types. Once you have created a guest-class,
you can select it by entering its mode. From here, you can then configure a further
set of operational settings specifically for the new guest-class. These settings can
then all be applied to a guest link by running the switchport atmf-guestlink
command. The following settings can be configured from each guest class mode:
•discovery method
•model type
• http-enable setting
• guest port, user name, and password
The no variant of this command removes the guest-class. Note that you cannot
remove a guest-class that is assigned to a port.
Syntax
atmf guest-class <guest-class-name>
no atmf guest-class
Mode Interface
Example 1 To create a guest-class named camera use the following commands:
node1# configure terminal
node1(config)# atmf guest-class camera
node1(config-atmf-guest)# end
Example 2 To remove the guest-class named phone use the following commands:
node1# configure terminal
node1(config)# no atmf guest-class phone
node1(config-atmf-guest)# end
Related
Commands
show atmf area guests
discovery
http-enable
username
modeltype
switchport atmf-guestlink
Parameter Description
<guest-class-name> The name assigned to the guest-class type. This can be
chosen from an arbitrary string of up to 15 characters.
To Next Page
Loading...
