C613-50105-01 REV C Command Reference for x210 Series 1192
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
MODELTYPE
modeltype
Overview This command sets the expected model type of the guest node. Guest nodes can
be one of various types: alliedware, aw+, tq or other. The model type will default to
other if nothing is set.
Use the no variant of this command to reset the model type to other.
Syntax
modeltype [alliedware|aw+|tq|other]
Default Will default to other
Mode ATMF Guest Configuration Mode
Example 1 To assign the model type tq to the guest-class called tq_device, use the following
commands:
node1# conf t
node1(config)# atmf guest-class tq_device
node1(config-atmf-guest)# modeltype tq
node1(config-atmf-guest)# end
Example 2 To remove the model type tq from the guest-class called tq_device, and reset it to
the default of other, use the following commands:
node1# conf t
node1(config)# atmf guest-class tq_device
node1(config-atmf-guest)# no modeltype
node1(config-atmf-guest)# end
Related
Commands
atmf guest-class
switchport atmf-guestlink
show atmf links guest
Parameter Description
alliedware A legacy Allied Telesis operating system.
aw+ The Allied Telesis AlliedWare Plus operating system.
tq An Allied Telesis TQ Series wireless access point.
other Used where the model type is outside the above definitions.
To Next Page
Loading...
