Allied Telesis AT-x210-9GT - Show Atmf Backup Area

C613-50105-01 REV C Command Reference for x210 Series 1213
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF BACKUP AREA
show atmf backup area
Overview Use this command to display backup status information for the master nodes in
one or more areas.
Note that this command is only available on AMF controllers.
Syntax
show atmf backup area [<area-name> [<node-name>]] [logs]
Mode Privileged Exec
Example To show information about backups for an area, use the command:
controller-1# show atmf backup area
Parameter Description
logs Displays the logs for the last backup of each node.
<area-name> Displays information about nodes in the specified area.
<node-name> Displays information about the specified node.