Allied Telesis AT-x210-9GT - Show Atmf Links Detail

C613-50105-01 REV C Command Reference for x210 Series 1227
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF LINKS DETAIL
show atmf links detail
Overview This command displays detailed information on all the links configured in the AMF
network. It can only be run on AMF master and controller nodes.
Syntax
show atmf links detail
Mode User Exec
Example To display the AMF link details use this command:
device1# show atmf links detail
The output from this command will display all the internal data held for AMF links.
The following example gives details of the links that are summarized in the
example in show atmf links.
Parameter Description
detail Detailed AMF links information.
Table 43: Sample output from the show atmf links detail command
device1# show atmf links detail

--------------------------------------------------------------------------------
Crosslink Ports Information
--------------------------------------------------------------------------------
Port : sa1
Ifindex : 4501
Port Status : Down
Port State : Init
Last event : 
Port BPDU Receive Count : 0
Port : po10
Ifindex : 4610
Port Status : Up
Port State : Full
Last event : AdjNodeLSEPresent
Port BPDU Receive Count : 140
Adjacent Node Name : Building-B
Adjacent Ifindex : 4610
Adjacent MAC : eccd.6dd1.64d0
Port Last Message Response : 0