C613-50105-01 REV C Command Reference for x210 Series 1262
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SWITCHPORT
ATMF-LINK
switchport atmf-link
Overview This command enables you to configure a port or aggregator to be an AMF
uplink/downlink. Running this command will automatically place the port or
aggregator into trunk mode.
Use the no variant of this command to remove any AMF-link that may exist for the
selected port or aggregated link.
Syntax
switchport atmf-link
no switchport atmf-link
Mode Interface Configuration for a switchport, a static aggregator or a dynamic channel
group.
Example To make a switchport 1.0.1 an AMF uplink/downlink, use the following commands
Node_1# configure terminal
Node_1(config)# interface port1.0.1
Node_1(config-if)# switchport atmf-link
To Next Page
Loading...
