Allied Telesis AT-x210-9GT - Chapter 38: NTP Commands; Introduction; NTP Commands

38
C613-50105-01 REV C Command Reference for x210 Series 1304
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
the Network Time Protocol (NTP). For more information, see the NTP Feature
Overview and Configuration Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“ntp access-group” on page 1305
•“ntp authenticate” on page 1306
•“ntp authentication-key” on page 1307
•“ntp broadcastdelay” on page 1308
•“ntp discard” on page 1309
•“ntp master” on page 1310
•“ntp peer” on page 1311
•“ntp restrict” on page 1313
•“ntp server” on page 1315
•“ntp source” on page 1317
•“ntp trusted-key” on page 1319
•“show counter ntp (deprecated)” on page 1320
•“show ntp associations” on page 1321
•“show ntp counters” on page 1323
•“show ntp counters associations” on page 1325
•“show ntp status” on page 1327