C613-50105-01 REV C Command Reference for x210 Series 1308
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP COMMANDS
NTP
BROADCASTDELAY
ntp broadcastdelay
Overview Use this command to set the estimated round-trip delay for broadcast packets.
Use the no variant of this command to reset the round-trip delay for broadcast
packets to the default offset of 0 microseconds.
Syntax
ntp broadcastdelay <delay>
no ntp broadcastdelay
Default 0 microsecond offset, which can only be applied with the no variant of this
command.
Mode Global Configuration
Examples To set the estimated round-trip delay to 23464 microseconds for broadcast
packets, use these commands:
awplus# configure terminal
awplus(config)# ntp broadcastdelay 23464
To reset the estimated round-trip delay for broadcast packets to the default setting
(0 microseconds), use these commands:
awplus# configure terminal
awplus(config)# no ntp broadcastdelay
Parameter Description
<delay> <1-999999> The broadcast delay in microseconds.
To Next Page
Loading...
