C613-50105-01 REV C Command Reference for x210 Series 1325
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
NTP COMMANDS
SHOW
NTP COUNTERS ASSOCIATIONS
show ntp counters associations
Overview Use this command to display NTP packet counters for individual servers and peers.
Syntax
show ntp counters associations
Mode User Exec/Privileged Exec
Examples To display packet counters for each NTP server and peer that is associated with this
device, use the command:
awplus# show ntp counters associations
Output Figure 38-2: Example output from show ntp counters associations
awplus#show ntp counters associations
Peer time-server.example.com
sent: 123
received: 122
auth-failed: 0
bogus-origin: 0
duplicate: 0
bad-header: 0
kod-received: 0
Table 38-2: Parameters in the output from show ntp counters associations
Parameter Description
Peer An NTP peer or server that the device is associated with.
sent The number of NTP packets that this device sent to the
peer.
received The number of NTP packets that this device received from
the peer.
auth-failed The number of NTP packets received that failed
authentication. NTP drops these packets. Packets can only
fail authentication if NTP authentication is enabled with
the ntp authenticate command
bogus-origin The number of packets received that have unexpected
timestamps. Such packets are not part of the current
request/reply round and may be faked.
duplicate The number of duplicate packets received. Such packets
are at best old duplicates and at worst a replay by a hacker.
Duplicates can happen in symmetric modes if the poll
intervals are uneven.
To Next Page
Loading...
