Allied Telesis AT-x210-9GT - Chapter 39: SNMP Commands; Introduction; SNMP Commands

39
C613-50105-01 REV C Command Reference for x210 Series 1328
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
SNMP. For more information, see:
•the Support for Allied Telesis Enterprise_MIBs in AlliedWare Plus, for
information about which MIB objects are supported.
•the SNMP Feature Overview and Configuration_Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“debug snmp” on page 1330
•“show counter snmp-server” on page 1331
•“show debugging snmp” on page 1335
•“show running-config snmp” on page 1336
•“show snmp-server” on page 1337
•“show snmp-server community” on page 1338
•“show snmp-server group” on page 1339
•“show snmp-server user” on page 1340
•“show snmp-server view” on page 1341
•“snmp trap link-status” on page 1342
•“snmp trap link-status suppress” on page 1344
•“snmp-server” on page 1346
•“snmp-server community” on page 1348
•“snmp-server contact” on page 1349
•“snmp-server enable trap” on page 1350
•“snmp-server engineID local” on page 1352