Allied Telesis AT-x210-9GT - Show Snmp-Server

C613-50105-01 REV C Command Reference for x210 Series 1337
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SNMP COMMANDS
SHOW
SNMP-SERVER
show snmp-server
Overview This command displays the status and current configuration of the SNMP server.
Syntax
show snmp-server
Mode Privileged Exec
Example To display the status of the SNMP server, use the command:
awplus# show snmp-server
Output Figure 39-4: Example output from the show snmp-server command
Related
Commands
debug snmp
show counter snmp-server
snmp-server
snmp-server engineID local
snmp-server engineID local reset
SNMP Server .......................... Enabled
IP Protocol .......................... IPv4
SNMPv3 Engine ID (configured name) ... Not set
SNMPv3 Engine ID (actual) ............ 0x80001f888021338e4747b8e607