C613-50105-01 REV C Command Reference for x210 Series 1388
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LLDP
TLV-SELECT
lldp tlv-select
Overview This command enables one or more optional TLVs, or all TLVs, for transmission in
LLDP advertisements via the specified ports. The TLVs can be specified in any
order; they are placed in LLDP frames in a fixed order (as described in IEEE
802.1AB). The mandatory TLVs (Chassis ID, Port ID, Time To Live, End of LLDPDU)
are always included in LLDP advertisements.
In LLDP-MED advertisements the MAC/PHY Configuration/Status TLV will be
always be included regardless of whether it is selected by this command.
The no variant of this command disables the specified optional TLVs, or all optional
TLVs, for transmission in LLDP advertisements via the specified ports.
Syntax
lldp tlv-select {[<tlv>]...}
lldp tlv-select all
no lldp tlv-select {[<tlv>]...}
no lldp tlv-select all
Default By default no optional TLVs are included in LLDP advertisements. The MAC/PHY
Configuration/Status TLV ( mac-phy-config) is included in LLDP-MED
advertisements whether or not it is selected by this command.
Mode Interface Configuration
Parameter Description
<tlv> The TLV to transmit in LLDP advertisements. One of
these keywords:
• port-description (specified by the description
(interface) command)
• system-name (specified by the hostname command)
• system-description
• system-capabilities
• management-address
•port-vlan
• port-and-protocol-vlans
• vlan-names
•protocol-ids
•mac-phy-config
• power-management (Power Via MDI TLV)
• link-aggregation
• max-frame-size
all All TLVs.
To Next Page
Loading...
