Allied Telesis AT-x210-9GT - Chapter 44: Trigger Commands; Introduction; Trigger Commands

44
C613-50105-01 REV C Command Reference for x210 Series 1497
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Trigger Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
Triggers. For more information, see the Triggers Feature Overview and
Configuration Guide.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Command List •“active (trigger)” on page 1499
•“day” on page 1500
•“debug trigger” on page 1502
•“description (trigger)” on page 1503
•“repeat” on page 1504
•“script” on page 1505
•“show debugging trigger” on page 1507
•“show running-config trigger” on page 1508
•“show trigger” on page 1509
•“test” on page 1514
•“time (trigger)” on page 1515
•“trap” on page 1517
•“trigger” on page 1518
•“trigger activate” on page 1519
•“type atmf node” on page 1520
•“type cpu” on page 1523
•“type interface” on page 1524
•“type memory” on page 1525