C613-50105-01 REV C Command Reference for x210 Series 1499
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
ACTIVE
(TRIGGER)
active (trigger)
Overview This command enables a trigger. This allows the trigger to activate when its trigger
conditions are met.
The no variant of this command disables a trigger. While in this state the trigger
cannot activate when its trigger conditions are met.
Syntax
active
no active
Mode Trigger Configuration
Usage Configure a trigger first before you use this command to activate it.
For information about configuring a trigger, see the Triggers Feature Overview and
Configuration Guide.
Examples To enable trigger 172, so that it can activate when its trigger conditions are met,
use the commands:
awplus# configure terminal
awplus(config)# trigger 172
awplus(config-trigger)# active
To disable trigger 182, preventing it from activating when its trigger conditions are
met, use the commands:
awplus# configure terminal
awplus(config)# trigger 182
awplus(config-trigger)# no active
Related
Commands
show trigger
trigger
To Next Page
Loading...
