C613-50105-01 REV C Command Reference for x210 Series 1509
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
SHOW
TRIGGER
show trigger
Overview This command displays configuration and diagnostic information about the
triggers configured on the device. Specify the show trigger command without
any options to display a summary of the configuration of all triggers.
Syntax
show trigger [<1-250>|counter|full]
Mode Privileged Exec
Example To get summary information about all triggers, use the following command:
awplus# show trigger
Parameter Description
<1-250> Displays detailed information about a specific trigger, identified by its
trigger ID.
counter Displays statistical information about all triggers.
full Displays detailed information about all triggers.
Table 1: Example output from the show trigger command
Table 2: Parameters in the output of the show trigger command
Parameter Description
TR# Trigger identifier (ID).
Type &
Details
The trigger type, followed by the trigger details in brackets.
Name Descriptive name of the trigger configured with the description
(trigger) command.
Ac Whether the trigger is active (Y), or inactive (N).
Te Whether the trigger is in test mode (Y) or not (N).
Tr Whether or not the trigger is enabled to send SNMP traps. See the trap
command.
Repeat Whether the trigger repeats continuously, and if not, the configured
repeat count for the trigger. To see the number of times a trigger has
activated, use the show trigger <1-250> command.
To Next Page
Loading...
