C613-50105-01 REV C Command Reference for x210 Series 1554
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
UP
-COUNT
up-count
Overview This command sets the number of consecutive pings that the polling instance
must receive a reply to before classifying the device reachable again.
The no variant of this command resets the up count to the default of 30.
Syntax
up-count <1-100>
no up-count
Default The default is 30.
Mode Ping-Polling Configuration
Examples To set the upcount to 5 consecutive pings for ping-polling instance 45, use the
commands:
awplus# configure terminal
awplus(config)# ping-poll 45
awplus(config-ping-poll)# up-count 5
To reset the upcount to the default value of 30 consecutive pings for ping-polling
instance 45, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 45
awplus(config-ping-poll)# no up-count
Related
Commands
critical-interval
fail-count
normal-interval
ping-poll
sample-size
show ping-poll
timeout (ping polling)
Parameter Description
<1-100> Number of replied pings before an unreachable device is classified as
reachable.
To Next Page
Loading...
