Allied Telesis AT-x210-9GT - Chapter 5: GUI Commands; GUI Commands; Introduction

5
C613-50105-01 REV C Command Reference for x210 Series 156
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
GUI Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
the GUI. For more information, see the Getting Started with Alliedware Plus
Command List •“atmf topology-gui enable” on page 157
•“gui-timeout” on page 158
•“log event-host” on page 159
•“service http” on page 160
•“show http” on page 161