C613-50105-01 REV C Command Reference for x210 Series 193
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
DEBUGGING
show debugging
Overview This command displays information for all debugging options.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show debugging
Default This command runs all the show debugging commands in alphabetical order.
Mode User Exec and Privileged Exec
Usage This command displays all debugging information, similar to the way the show
tech-support command displays all show output for use by Allied Telesis
authorized service personnel only.
Example To display all debugging information, use the command:
awplus# show debugging
Output Figure 6-4: Example output from the show debugging command
awplus#show debugging
AAA debugging status:
Authentication debugging is off
Accounting debugging is off
% DHCP Snooping service is disabled
802.1X debugging status:
EPSR debugging status:
EPSR Info debugging is off
EPSR Message debugging is off
EPSR Packet debugging is off
EPSR State debugging is off
IGMP Debugging status:
IGMP Decoder debugging is off
IGMP Encoder debugging is off
...
To Next Page
Loading...
