C613-50105-01 REV C Command Reference for x210 Series 210
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM INTERRUPTS
show system interrupts
Overview Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show system interrupts
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus# show system interrupts
Output Figure 6-18: Example output from the show system interrupts command
Related
Commands
show system environment
awplus>show system interrupts
CPU0
3: 252 Enabled 0 MIPS serial
5: 17660130 Enabled 0 MIPS linux-kernel-bde
6: 30 Enabled 0 MIPS GPIO
7: 1104713081 Enabled 0 MIPS timer
ERR 0
To Next Page
Loading...
