Allied Telesis AT-x210-9GT - Chapter 7: Pluggables and Cabling Commands; Introduction; Pluggables and Cabling Commands

7
C613-50105-01 REV C Command Reference for x210 Series 220
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Pluggables and
Cabling Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
and monitor Pluggables and Cabling, including:
• Cable Fault Locator for finding faults in copper cabling
• Optical Digital Diagnostic Monitoring (DDM) to help find fiber issues when
links go down
• Active Fiber Monitoring for detecting changes in optical power received over
fiber cables.
For more information, see the Pluggables and Cabling Feature Overview and
Configuration_Guide.
Command List •“clear test cable-diagnostics tdr” on page 221
•“debug fiber-monitoring” on page 222
•“fiber-monitoring action” on page 224
•“fiber-monitoring baseline” on page 225
•“fiber-monitoring enable” on page 227
•“fiber-monitoring interval” on page 228
•“fiber-monitoring sensitivity” on page 229
•“show system fiber-monitoring” on page 231
•“show system pluggable” on page 234
•“show system pluggable detail” on page 236
•“show system pluggable diagnostics” on page 239
•“show test cable-diagnostics tdr” on page 241
•“test cable-diagnostics tdr interface” on page 242