Allied Telesis AT-x210-9GT - Default Log Monitor

C613-50105-01 REV C Command Reference for x210 Series 253
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LOGGING COMMANDS
DEFAULT
LOG MONITOR
default log monitor
Overview This command restores the default settings for log messages sent to the terminal
when a terminal monitor command is used.
Syntax
default log monitor
Default All messages are sent to the terminal when a terminal monitor command is used.
Mode Global Configuration
Example To restore the log monitor to its default settings use the following commands:
awplus# configure terminal
awplus(config)# default log monitor
Related
Commands
log monitor (filter)
log monitor exclude
show log config
terminal monitor