C613-50105-01 REV C Command Reference for x210 Series 345
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
INTERFACE TESTING COMMANDS
SERVICE
TEST
service test
Overview This command puts the device into the interface testing state, ready to begin
testing. After entering this command, enter Interface Configuration mode for the
desired interfaces and enter the command test interface.
Do not test interfaces on a device that is part of a live network—disconnect the
device first.
Use the no variant of this command to stop the test service.
Syntax
service test
no service test
Mode Global Configuration
Example To put the device into a test state, use the command:
awplus(config)# service test
Related
Commands
test interface
To Next Page
Loading...
