C613-50105-01 REV C Command Reference for x210 Series 391
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
PLATFORM
show platform
Overview This command displays the settings configured by using the platform commands.
Syntax
show platform
Mode Privileged Exec
Usage This command displays the settings in the running config. For changes in some of
these settings to take effect, the device must be rebooted with the new settings in
the startup config.
Example To check the settings configured with platform commands on the device, use the
following command:
awplus# show platform
Output Figure 13-7: Example output from the show platform command
awplus# show platform
MAC vlan hashing algorithm crc32l
stop-unreg-mc-flooding off
Table 5: Parameters in the output of the show platform command
Parameter Description
MAC vlan hashing
algorithm
The MAC VLAN hash-key-generating algorithm (set with
the platform mac-vlan-hashing-algorithm command). The
default algorithm is crc32l. The algorithm may need to be
changed in rare circumstances in which hash collisions
occur.
Load Balancing Which packet fields are used in the channel load
balancing algorithm (set with the platform load-balancing
command).
stop-unreg-mc-flooding Whether the stop-unreg-mc-flooding feature is on or off
(set with the platform stop-unreg-mc-flooding
command). This feature prevents flooding of unregistered
multicast packets in the occasional situations in which
IGMP snooping does not prevent it.
To Next Page
Loading...
