C613-50105-01 REV C Command Reference for x210 Series 425
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
ACCESS VLAN
switchport access vlan
Overview Use this command to change the port-based VLAN of the current port.
Use the no variant of this command to change the port-based VLAN of this port to
the default VLAN, vlan1.
Syntax
switchport access vlan <vlan-id>
no switchport access vlan
Default Reset the default VLAN 1 to specified switchports using the negated form of this
command.
Mode Interface Configuration
Usage Any untagged frame received on this port will be associated with the specified
VLAN.
Examples To change the port-based VLAN to VLAN 3 for port1.0.2, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport access vlan 3
To reset the port-based VLAN to the default VLAN 1 for port1.0.2, use the
commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no switchport access vlan
Related
Commands
show interface switchport
show vlan
Parameter Description
<vlan-id> <1-4094> The port-based VLAN ID for the port.
To Next Page
Loading...
