Allied Telesis AT-x210-9GT - Switchport Private-Vlan Mapping

C613-50105-01 REV C Command Reference for x210 Series 435
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
SWITCHPORT
PRIVATE-VLAN MAPPING
switchport private-vlan mapping
Overview Use this command to associate a primary VLAN and a set of secondary VLANs to a
promiscuous port.
Use the no variant of this to remove all the association of secondary VLANs to
primary VLANs for a promiscuous port.
Syntax
switchport private-vlan mapping <primary-vlan-id> add
<secondary-vid-list>
switchport private-vlan mapping <primary-vlan-id> remove
<secondary-vid-list>
no switchport private-vlan mapping
Mode Interface Configuration
Usage This command can be applied to a switch port or a static channel group, but not a
dynamic (LACP) channel group. LACP channel groups (dynamic/LACP
aggregators) cannot be promiscuous ports in private VLANs.
Examples
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# switchport private-vlan mapping 2 add 3-4
awplus(config-if)# switchport private-vlan mapping 2 remove 3-4
awplus(config-if)# no switchport private-vlan mapping
Related
Commands
switchport mode private-vlan
Parameter Description
<primary-vlan-id> VLAN ID of the primary VLAN.
<secondary-vid-list> VLAN ID of the secondary VLAN (either isolated or
community), or a range of VLANs, or a comma-separated
list of VLANs and ranges.