Allied Telesis AT-x210-9GT - Vlan Classifier Activate

C613-50105-01 REV C Command Reference for x210 Series 445
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VLAN COMMANDS
VLAN
CLASSIFIER ACTIVATE
vlan classifier activate
Overview Use this command in Interface Configuration mode to associate a VLAN classifier
group with the switch port.
Use the no variant of this command to remove the VLAN classifier group from the
switch port.
Syntax
vlan classifier activate <vlan-class-group-id>
no vlan classifier activate <vlan-class-group-id>
Mode Interface Configuration mode for a switch port or link aggregator.
Usage See the protocol-based VLAN configuration example in the VLAN Feature
Overview and Configuration Guide for configuration details.
Example To associate VLAN classifier group 3 with switch port1.0.3, enter the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# vlan classifier activate 3
To remove VLAN classifier group 3 from switch port1.0.3, enter the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.3
awplus(config-if)# no vlan classifier activate 3
Related
Commands
show vlan classifier rule
vlan classifier group
vlan classifier rule ipv4
vlan classifier rule proto
Parameter Description
<vlan-class-group-id> Specify a VLAN classifier group identifier in the range
<1-16>.