Allied Telesis AT-x210-9GT - Chapter 15: Spanning Tree Commands; Introduction; Spanning Tree Commands

15
C613-50105-01 REV C Command Reference for x210 Series 452
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Spanning Tree
Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
RSTP, STP or MSTP. For information about spanning trees, including configuration
procedures, see the STP Feature Overview and Configuration Guide.
Command List •“clear spanning-tree statistics” on page 454
•“clear spanning-tree detected protocols (RSTP and MSTP)” on page 455
•“debug mstp (RSTP and STP)” on page 456
•“instance priority (MSTP)” on page 460
•“instance vlan (MSTP)” on page 462
•“region (MSTP)” on page 464
•“revision (MSTP)” on page 465
•“show debugging mstp” on page 466
•“show spanning-tree” on page 467
•“show spanning-tree brief” on page 470
•“show spanning-tree mst” on page 471
•“show spanning-tree mst config” on page 472
•“show spanning-tree mst detail” on page 473
•“show spanning-tree mst detail interface” on page 475
•“show spanning-tree mst instance” on page 477
•“show spanning-tree mst instance interface” on page 478
•“show spanning-tree mst interface” on page 479
•“show spanning-tree mst detail interface” on page 480
•“show spanning-tree statistics” on page 482