C613-50105-01 REV C Command Reference for x210 Series 464
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SPANNING TREE COMMANDS
REGION
(MSTP)
region (MSTP)
Overview Use this command to assign a name to the device’s MST Region. MST Instances
(MSTI) of a region form different spanning trees for different VLANs.
Use this command for MSTP only.
Use the no variant of this command to remove this region name and reset it to the
default.
Syntax
region <region-name>
no region
Default By default, the region name is My Name.
Mode MST Configuration
Usage The region name, the revision number, and the digest of the VLAN to MSTI
configuration table must be the same on all devices that are intended to be in the
same MST region.
Example
awplus# configure terminal
awplus(config)# spanning-tree mst configuration
awplus(config-mst)# region ATL
Related
Commands
revision (MSTP)
show spanning-tree mst config
Parameter Description
<region-name> Specify the name of the region, up to 32 characters. Valid
characters are upper-case, lower-case, digits, underscore.
To Next Page
Loading...
