C613-50105-01 REV C Command Reference for x210 Series 549
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LINK AGGREGATION COMMANDS
SHOW
STATIC-CHANNEL-GROUP
show static-channel-group
Overview Use this command to display all configured static channel groups and their
corresponding member ports. Note that a static channel group is the same as a
static aggregator.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the action parameter of the thrash-limiting command is set to
vlan-disable, the output will also show the VLANs on which thrashing is detected.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide, which is
available on our website at alliedtelesis.com.
Syntax
show static-channel-group
Mode User Exec and Privileged Exec
Example
awplus# show static-channel-group
Output Example output from show static-channel-group
Related
Commands
static-channel-group
% LAG Maximum : 8
% LAG Static Maximum: 8
% LAG Dynamic Maximum: 8
% LAG Static Count : 0
% LAG Dynamic Count : 0
% LAG Total Count : 0
To Next Page
Loading...
