C613-50105-01 REV C Command Reference for x210 Series 560
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IP ADDRESSING AND PROTOCOL COMMANDS
ARP
-REPLY-BC-DMAC
arp-reply-bc-dmac
Overview Use this command to allow processing of ARP replies that arrive with a broadcast
destination MAC (ffff.ffff.ffff). This makes neighbors reachable if they send ARP
responses that contain a broadcast destination MAC.
Use the no variant of this command to turn off processing of ARP replies that arrive
with a broadcast destination MAC.
Syntax
arp-reply-bc-dmac
no arp-reply-bc-dmac
Default By default, this functionality is disabled.
Mode Interface Configuration for VLAN interfaces
Example To allow processing of ARP replies that arrive on VLAN2 with a broadcast
destination MAC, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# arp-reply-bc-dmac
Related
Commands
clear arp-cache
show arp
To Next Page
Loading...
