C613-50105-01 REV C Command Reference for x210 Series 598
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
STATIC ROUTING COMMANDS FOR MANAGEMENT PURPOSES
MAX
-STATIC-ROUTES
max-static-routes
Overview Use this command to set the maximum number of static routes, excluding FIB
(Forwarding Information Base) routes.
NOTE: For FIB routes use the max-fib-routes command.
Use the no variant of this command to set the maximum number of static routes
to the default of 1000 static routes.
Syntax
max-static-routes <1-1000>
no max-static-routes
Default The default number of static routes is the maximum number of static routes (1000).
Mode Global Configuration
Example To reset the maximum number of static routes to the default maximum, use the
command:
awplus# configure terminal
awplus(config)# no max-static-routes
NOTE: Static routes are applied before adding routes to the RIB (Routing Information
Base). Therefore, rejected static routes will not appear in the running config.
Related
Commands
max-fib-routes
To Next Page
Loading...
