Allied Telesis AT-x210-9GT - Chapter 20 IGMP and IGMP Snooping Commands; Introduction

20
C613-50105-01 REV C Command Reference for x210 Series 604
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP and IGMP
Snooping
Commands
Introduction
Overview Devices running AlliedWare Plus use IGMP (Internet Group Management Protocol)
and MLD (Multicast Listener Discovery) to track which multicast groups their clients
belong to. This enables them to send the correct multimedia streams to the correct
destinations. IGMP is used for IPv4 multicasting, and MLD is used for IPv6
multicasting.
This chapter describes the commands to configure IGMP Querier behaviour and
selection and IGMP Snooping.
Command List •“clear ip igmp” on page 606
•“clear ip igmp group” on page 607
•“clear ip igmp interface” on page 608
•“debug igmp” on page 609
•“ip igmp” on page 610
•“ip igmp access-group” on page 611
•“ip igmp flood specific-query” on page 612
•“ip igmp immediate-leave” on page 613
•“ip igmp last-member-query-count” on page 614
•“ip igmp last-member-query-interval” on page 615
•“ip igmp limit” on page 616
•“ip igmp maximum-groups” on page 617
•“ip igmp querier-timeout” on page 619
•“ip igmp query-holdtime” on page 620
•“ip igmp query-interval” on page 622
•“ip igmp query-max-response-time” on page 624